Plumbing in Willmott

Homes in Willmott

Willmott is one of the Milton neighbourhoods built during the town's big growth years. The housing is mostly detached homes and townhouses with modern materials: plastic drains, PEX or copper supply, and mechanical rooms in the basement. Parks and schools are close by, and a lot of the homes have growing households that use far more water than the original builder plumbing was ever stressed with.

Common plumbing calls here

• Sump pumps failing for the first time
• Basement bathrooms going into existing rough-ins
• Running toilets and worn fill valves
• Kitchen drain clogs from busy family kitchens
• Water heater replacements, rented or owned

Basement bathrooms are the big project here. If you are planning one, read our guide to planning a basement bathroom and see the bathroom renovation page for what we handle.

Water, drains and the local ground

Like much of Milton, Willmott sits on clay that holds water after heavy rain and spring melt. That keeps sump pits busy. A pump that has run reliably for ten years can quit with little warning, and a finished basement raises the stakes. Hard water also means scale in kettles, dishwashers and the bottom of the water heater. Our hard water pamphlet explains what to expect and when softening is worth it.

Expansion tanks are another quiet item. Many homes here have a check valve or regulator on the incoming service, which means water heated in the tank has nowhere to expand. Without an expansion tank, pressure spikes can make relief valves drip and shorten the life of fixtures and appliances. It is a small part that is easy to check during any other visit, and one we will point out if it is missing.

Getting a plumber out

Willmott is a short trip for us. When you call, tell us if the basement is finished and whether there are access panels near the problem. Let us know if the issue started after a renovation or appliance install, since that often points straight at the cause. If the floor drain is pushing water up, hold off on every tap and toilet until we have looked.

For a sump pump that has stopped, check the breaker or GFCI outlet it plugs into first, then lift the float gently to see if it starts. If it still sits silent, call us before the water reaches the top of the pit. A pit fills faster than most people expect on a wet April night, and the time to sort it out is while the floor is still dry. We will tell you plainly whether the pump needs a repair, a replacement, or just a reset.