Leak Detection in Milton
A water bill that jumps, a meter that spins with every tap closed, a stain that grows. The leak is somewhere. Our job is to find it without tearing the house apart.
- Hidden leaks found with a moisture meter, not a crowbar
- Split sections cut out and replaced, not clamped
- House held under pressure after the repair
- Main shut-off checked before we leave
- Licensed plumbing trade
- Booked around your day
- Price agreed before work
- Phone only, no forms
On the truck
- Moisture meter and thermal look
- PEX crimper, copper torch, push fittings
- Pressure gauge on a hose bib
Tested before we leave
- House held under pressure after the repair
- Every joint wiped dry and looked at again
- Main shut-off worked before we leave
How pricing works
Quoted on site, after we have opened it up and found the cause. Nothing starts without your yes.
| You notice | Usual cause | On the job |
|---|---|---|
| Stain spreading on the ceiling | Leak at a fitting in the floor above | Moisture meter, open a small hole, repair |
| Meter dial moving with taps off | Hidden leak on the supply side | Isolate zones, pressure-test each |
| Pinholes in copper, green crust | Corrosion from water chemistry | Replace the run in PEX or copper |
When you need leak detection
- The water bill rose and nothing changed in the household.
- The meter moves with all fixtures off.
- A ceiling stain, warped floor or musty corner with no obvious source.
- A hiss of water with every tap shut.
- Warm spots in a floor, which can mean a hot line leaking below.
What the visit looks like
We start simple. With every fixture off, we read the meter, wait, and read it again. Movement means water is going somewhere. Then we isolate: close the toilet stops one at a time, then the water heater cold supply, then branch valves if the house has them. Each step narrows the field.
Toilets are tested with dye in the tank; a slow flapper leak can waste a surprising amount. For hidden lines, we use moisture meters on drywall and flooring, thermal imaging for hot lines, and listening equipment that picks up the hiss of pressurized water behind walls and under slabs. Only when the signals agree do we open a wall, and then only as much as the repair needs.
Try this first: our toilet dye test pamphlet. It finds the most common silent leak in about fifteen minutes.
Milton homes and this problem
In newer Milton homes, the usual hidden leaks are at PEX crimp or push fittings behind tub surrounds, at the drain connection under a second-floor shower, and at the ice maker line behind the fridge. In older houses, pinholes in aging copper and corroded galvanized joints are more common. Hard water plays its part: scale wears valve seats and toilet flappers faster than in soft water towns.
What affects the cost
- How quickly isolation narrows the search.
- Whether specialised listening or imaging is needed.
- Access: open ceilings, finished drywall, tile or concrete.
- The repair itself once the leak is found.
Doing it yourself vs calling
The meter test and the dye test are free and worth doing before you call. If both point to a leak you cannot see, ring us before the water finds its way into framing and insulation.
Questions we get asked
How can I tell if I have a hidden leak?
Turn off every fixture and watch the water meter. If it still moves, water is leaving the system somewhere.
Will you have to open my walls?
Only once the readings agree on a spot, and only as much as needed for the repair.
Can a toilet cause a high water bill?
Yes. A flapper that seeps can run all day and night without you noticing.