Whole-Home Repiping in Milton
When pinhole leaks keep appearing and the pressure keeps dropping, patching becomes a hobby. Repiping replaces the supply lines so the house can stop surprising you.
- Hidden leaks found with a moisture meter, not a crowbar
- Split sections cut out and replaced, not clamped
- House held under pressure after the repair
- Main shut-off checked before we leave
- Licensed plumbing trade
- Booked around your day
- Price agreed before work
- Phone only, no forms
On the truck
- Moisture meter and thermal look
- PEX crimper, copper torch, push fittings
- Pressure gauge on a hose bib
Tested before we leave
- House held under pressure after the repair
- Every joint wiped dry and looked at again
- Main shut-off worked before we leave
How pricing works
Quoted on site, after we have opened it up and found the cause. Nothing starts without your yes.
| You notice | Usual cause | On the job |
|---|---|---|
| Stain spreading on the ceiling | Leak at a fitting in the floor above | Moisture meter, open a small hole, repair |
| Meter dial moving with taps off | Hidden leak on the supply side | Isolate zones, pressure-test each |
| Pinholes in copper, green crust | Corrosion from water chemistry | Replace the run in PEX or copper |
When you need repiping
- Old galvanized water pipe choked with internal rust.
- Repeated pinhole leaks in old copper.
- Polybutylene or recalled Kitec piping.
- Brown or rusty water from the cold tap.
- A renovation that opens walls anyway.
What the visit looks like
We walk the house and map what is there: where the service comes in, how the lines branch, which materials were used and which have already been patched. Then we plan a route for the new piping. In most homes we use PEX for its flexibility through existing framing, with copper or brass at the main and the water heater. Each fixture gets its own accessible shut-off.
Work goes floor by floor. We keep water on overnight where we can, so the house stays livable. Openings in walls and ceilings are kept small and placed where they are easiest to patch. When the new system is in, we pressure test it before closing anything and before we remove the old lines.
Plain fact: repiping is a big job done once. A good plan up front keeps it from becoming a long one.
Milton homes and this problem
In the original town and the oldest crescents, galvanized supply is still turning up, sometimes alongside copper added during later renovations. Some Milton houses built in the late 1990s and early 2000s were plumbed with Kitec, the orange and blue pipe with brass fittings; our pamphlet on Kitec plumbing explains why owners replace it. Hard water speeds wear on older copper. For homes with low pressure, repiping is often paired with water service replacement from the street.
What affects the cost
- Size of the house and number of fixtures.
- Finished walls and ceilings.
- Materials chosen.
- Whether the water service line is replaced too.
- Drywall repair, which some owners handle with their own contractor.
Doing it yourself vs calling
Repiping is a plumber's job. What helps is clearing access in the basement, locating hidden panels, and deciding in advance which walls you are happy to have opened.
Questions we get asked
How long does a whole-house repipe take?
A typical house takes a few days, depending on size, access and finishes.
Will I have water during the work?
Usually in the evenings, yes. We plan the work to keep the house usable.
Is PEX as good as copper?
For most homes it is a reliable choice, flexible and resistant to the scale and pinholes that affect older copper.